I have a 4’x8’ fab table with a 1/4” top and built with 3”x3”x3/16” legs and 2”x2”x1/4” angle it also has casters on it as well to make it easy to move around. Along with 26 gallon quiet running kobalt compressor to run the miller spectrum 375 plasma cutter. The plasma runs perfect and cuts up to 3/8”. I never cut anything more than 1/4” with it. The welder is a Hobart Ironman 250. The fan motor kind of runs a little rough sometimes but I have an extra motor for it if it ever goes out. I also have regulators and hoses and torch as well. No cylinders for a torch setup. I have a cylinder of 75/25 for the welder that comes with it. It currently has roughly 1100 pounds in it. I’m asking $3000 for everything. I won’t split it apart it’s all or nothing. I’m open to offers as well. Please pardon the mess on the table. I haven’t had time to get in there and clean it up. Pick up in Lebanon.